Furnace Cleaning
Step 1... Hi-Tech Rotary Brush
With your furnace duct system under suction,
our technician will Brush the inside duct walls, tops, and
bottoms of your furnace ducts from the register all the way to the main
lines....removing the caked on dirt and dust.
Step 2... Whip or Skipper
Line
After your ducts have been brushed, our technician uses a whip or skipper line which snakes it's way from the
register to the main lines discharging high pressure air in a 360
degree pattern. This ensures that even the smallest dust particles are
removed from the duct. This device will also clean the damper and duct
transition deep in the duct system.
Then the main lines of the system
are cleaned with a large rotary brush to loosen all the caked on dirt
& debris. The reverse skipper, discharging high pressure air in a
reverse pattern is then to assist the vacuum in removing al the dust, dirt
& debris from the duct system.
Step 3... Inspection and Final Cleaning
The furnace, chimney and all combustion
components are cleaned and inspected. The heat exchanger is visually
inspected for stress cracks. The fan & motor are cleaned and
lubricated. The burners on the hot water tank are cleaned and a
multi-point system check is performed. If the system has air conditioning,
both sides of the coil are carefully cleaned with high pressure air and if
required a hot water wash. A build up of 1/16 of an inch of dirt on a coil
can reduce efficiency by up to 20%.
Furnace Cleaning
- Duct Cleaning Solutions Advanced
Cleaning http://www.advancecleaning.ca
